Lightweight joint compound
30% lighter than conventional ready mix
- Approximately 30% lighter than conventional ProForm® Joint Compound.
- Up to 33% less shrinkage than conventional joint compound.
- Mold Resistant.
ProForm® Lite Joint Compound is a vinyl base ready mix lightweight joint compound. Approximately 30% lighter than conventional ready mix, Lite Joint Compound pulls and sands easier and reduces shrinkage by up to 33%.
Lite Joint Compound is designed for use in finishing gypsum board joints, spotting fasteners and finishing cornerbead.
- Lightweight. Approximately 30% lighter than conventional ProForm Joint Compound.
- Reduced shrinkage. Up to 33% less shrinkage than conventional joint compound.
- Superior finish. Provides a finish with less pocking and pin holing.
- Easier pull. Spreads easier for quick application.
- Finishes metal beads with two coats.
- Excellent sanding characteristics.
- Ready to use right from container.
- Mold resistant.
- Low VOC content - less than 2 grams/liter.
- Southwest Area Only
ProForm® Lite Joint Compound has achieved GREENGUARD Certification.
Products that suit any project criteria
123-140 lbs/9 gal per 1,000 sq ft
Frequently Asked Questions
Ready to answer your product and installation questions
No material can be considered “mold-proof,” nor is it certain that any material will resist mold or mildew indefinitely. However, when used in conjunction with good design, handling, and construction practices, ProForm ready mix can provide increased mold resistance versus standard ready-mixed compounds. As with any building material, avoiding water exposure during handling, storage and installation and after installation is complete is the best way to avoid the formation of mold or mildew.
A good rule of thumb is to use nine gallons of ready mix for every 1000 sq ft of wallboard.
Ready mix pails or cartons should not be stacked more than two pallets high.
Nine months in good storage conditions. To prevent spoilage and freezing, maintain temperature at a minimum 50˚F (10˚C) and protect container from exposure to extreme heat and sunlight.
While not ideal, ProForm joint compound can go through up to 3 freeze-thaw cycles. Allow material to thaw at room temperature for at least 24 hours. When thawed, turn the container upside-down for at least 15 minutes. Turn pail right-side up, remove the lid and immediately remix with an electric drill. Ready mix should be lump-free and ready to use within 1 minute. Discard ready mix that does not remix to a lump-free consistency.
Detailed information to support your next project
Product details and technical documentation
Design & Resources
Review ProForm details and technical information in the Design & Resource Center.Design & Resource Center
Contact ProForm representatives who can help troubleshoot your project challenges.Get Started
Need Technical Information?
National Gypsum Company is the exclusive service provider for products manufactured by ProForm Finishing Products, LLC.